Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Old Northeast?
Spring replacement in Old Northeast typically costs $180 – $340 for one spring, including the part and labor. Torsion and extension springs almost always come as a matched pair, so replacing both together usually runs about $360 – $680. A written estimate confirms your exact price before any work starts.
Spring Replacement Cost Breakdown (2026)
What you’ll pay depends on which spring failed, how many you replace, and how accessible the hardware is. Here’s how the work breaks down for Old Northeast homes:
| What’s being replaced | Typical estimated cost |
|---|---|
| One torsion spring (part and labor) | $180 – $340 |
| One extension spring (part and labor) | $180 – $340 |
| Matched pair, replaced together | About $360 – $680 |
| Cables, if frayed or stretched | $130 – $250 |
| Rollers, if worn | $110 – $220 |
| Opener repair, if the door strains your opener | $120 – $320 |
| Panel replacement, if a spring failure damaged a section | $250 – $500 |
| Track realignment, if the door shifted | $120 – $240 |
Those are typical estimated ranges, and the written estimate sets the final price. Spring prices are for one spring. Since springs wear on the same cycle, most homeowners replace the pair at once, which is why a pair costs about twice a single spring. A failing spring that’s left to run often takes a cable or roller with it, and that’s where the extra line items come from. On a door with only one spring, the single-spring price is the whole job.
What the workload looks like
Diagnosing a spring takes a few minutes: a technician checks the winding, measures the coil, and looks at the balance of the door. Installation involves unwinding the old spring under tension, mounting the new one, and setting the correct turns. Then we cycle the door, check the safety reverse, and adjust the opener if the door needs it. A single torsion spring is generally a short visit. A pair with a cable or roller replacement takes longer, which is one reason the estimate depends on what’s found once the door is inspected.
What Affects Spring Replacement Pricing in Old Northeast
- Torsion vs. extension springs. Torsion springs mount above the door and carry the load through a shaft; extension springs run along the tracks. Both sit in the same $180 – $340 range for one spring, but torsion work is more involved and is often the base of the quote on heavier doors.
- Number of springs. Modern doors usually carry two torsion springs. If you have a single spring, you pay for one. If you have a pair, the second spring gets replaced at the same time, which doubles the part and labor.
- Door weight and size. A wide double-car door, common on the older lots around Old Northeast, carries a heavier load than a single-car door. A heavier door needs a stronger spring, and that affects both the part cost and the labor time.
- Age of the surrounding parts (general wear, not a local measurement). Springs, cables, and rollers move together. Our spring replacement visits often turn up a frayed cable or a worn roller, and fixing it now is cheaper than fixing it after it fails.
- Access and clearance above the door. Old Northeast garages vary a lot in ceiling height and headroom above the opener rail. A tight, low-clearance setup takes more time to work around safely.
- The brand and model of your door and opener. We work on the brand you have, whether that’s LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, or Raynor. Mismatched parts or a nonstandard setup can mean a longer visit.
How Much Is a New Garage Door Spring in Old Northeast?
The spring itself is only part of the price. A spring for a typical residential door is a modest line item on its own. What makes up the rest of the $180 – $340 is the labor of installing it safely: unwinding the old spring under tension, setting the new one, and testing the door through a full cycle. That’s the part that matters when you’re pricing the job. A cheap spring bought online and installed without the right equipment can fail quickly or put someone in the hospital. If you want the full picture of how the repair works, not just the price, see our Garage Door Repair Old Northeast page.
Why Spring Work Is Not a Do-It-Yourself Job
Garage door springs sit under extreme tension. They store the full weight of the door. A torsion spring holds hundreds of pounds of force, and that force releases the instant the wrong rod or grip slips. Every year, spring work sends people to the emergency room when they try it on their own.
That’s why spring replacement is a dedicated, named service for us, not a side task. Our technicians know how to unwind, measure, and reset a spring safely, and they can do it without damaging the door or the opener. If your spring has snapped, don’t touch the door. Leave the door down, keep the area clear, and call a trained professional. Our technicians have up to 9 years of experience, and spring work is one of the jobs they do most.
Can You Replace a Broken Spring the Same Day?
In most cases, yes. We treat a broken spring as time-sensitive, and we offer emergency garage door service for doors that won’t move. If your car is trapped or the door won’t close, call us and we’ll get you on the schedule. Because we work on eight major garage and opener brands, we can usually match the spring to your door without waiting on a special order. From the spring to the opener, we can diagnose the whole system in one visit and fix the most urgent problem first.
How Do You Know Your Spring Needs Replacing?
A spring almost never fails without warning signs. Here’s what to watch for:
- A loud bang from the garage. This is the classic sound of a torsion spring breaking.
- The door feels much heavier than usual. A spring does most of the lifting, so when it weakens, the door gets hard to open by hand.
- A visible gap in the coil. A snapped torsion spring shows a clean break in the winding.
- The door slams down or hangs crooked. Unbalanced doors will drift or stop halfway.
- Half-open doors. A weak spring often lets the door start up and then stall partway.
If you see any of these, stop using the door and get it inspected. If the garage door opener is struggling too, you can check our opener repair service to see what’s covered.
How to Save on Spring Replacement
You can’t avoid the spring itself, but a few choices keep the total lower:
- Get a free estimate. Call (877) 492-1990 and we’ll give you an upfront price before any work starts, so there are no surprises.
- Replace both springs together. It feels like more upfront, but two springs usually wear out within about the same window. Replacing the pair once is cheaper than paying for two separate visits.
- Fix the small stuff now. If the inspection turns up a worn roller or a frayed cable, have it done at the same time. It saves the cost of a second visit.
- Don’t wait for a total failure. A door that’s hard to lift or hangs crooked is a warning sign. Catching it early can keep the spring from taking a cable or a panel with it.
- Keep your opener in good shape. A straining opener wears out faster and can strain the springs. A tune-up goes a long way, and our garage door repair service covers that.
Spring Replacement vs. New Door Installation
Sometimes the cheapest answer is spring replacement, and sometimes a new door makes more sense. Here’s the math for Old Northeast homeowners:
- Repair makes sense when the door panels, tracks, and opener are in good condition and only the spring has failed.
- Replacement makes sense when the door is at the end of its life, panels are damaged, or you keep repairing the same problems.
A new door installation in Old Northeast runs a typical $700 – $2,200, which is a bigger commitment than a spring repair. If you’re weighing it, we’ll walk you through the condition of your door and give you a straight answer on which way to go. You can read more about our garage door installation service for that option.
What’s Included in a Spring Replacement Visit
When you call us for spring work, here’s what a typical visit covers:
- Inspect the door, springs, cables, tracks, and rollers.
- Measure the springs and match the replacement to your door’s weight.
- Unwind the old spring safely and remove it.
- Install and set the new spring to the correct tension.
- Cycle the door, check balance, and test the safety reverse.
- Walk you through what was done and what, if anything, needs watching.
We do the inspection first, so the written estimate reflects the real job, not a guess. Free estimates mean you’ll know the price before we start. Our technicians are trained on the major brands, so if your door or opener is a LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, or Raynor, we can work with what you have.
What to Check Before You Book Spring Repair
A few quick checks help you and the technician:
- Note whether the door feels heavy or drifts when you lift it by hand (only if the spring isn’t broken; a broken spring means the door is too heavy to test).
- Look for a gap in the spring coil or a visible break.
- Write down the door and opener brand if you can find a label. We work on the brand you have, so it helps to know upfront.
- Clear the area around the door so the technician has room to work.
Why Choose a Specialist for Spring Replacement?
Springs are one of the most dangerous and technically demanding repairs on a garage door. A general handyman who “also does doors” may not have the equipment or the experience to set tension safely. Garage doors are all we do, and spring repair is a service we focus on. That means every technician on the job is a garage door specialist, not a generalist splitting time across several trades. From the spring to the opener, we can diagnose and fix the whole system in one visit, which usually saves you a second call.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Old Northeast?
Spring replacement in Old Northeast typically costs $180 – $340 for one spring. Since springs are usually replaced in pairs, expect about $360 – $680 for both. Call (877) 492-1990 for an exact quote, and the estimate is free.
Is it cheaper to repair or replace a garage door spring?
Repair is cheaper than replacing the door: a spring replacement runs $180 – $340 for one spring, versus $700 – $2,200 for a new door. Go with a new door only if the panels, tracks, or opener are also failing. Call (877) 492-1990 and we’ll tell you which makes sense for your door.
How much does a broken garage door spring cost to fix in Old Northeast?
Fixing a broken spring runs a typical $180 – $340 for one spring, and most doors need both springs replaced, so budget about $360 – $680. The written estimate sets the final price. Call (877) 492-1990 to schedule an inspection.
Can you replace my garage door spring the same day?
In most cases, yes. We treat broken springs as time-sensitive and offer emergency garage door service, so a door that won’t open can often be handled the same day. Call (877) 492-1990 and we’ll get you on the schedule.
What affects the price of spring replacement in Old Northeast?
The big factors are how many springs you have, the type (torsion or extension), and whether cables or rollers also need replacing. One spring is $180 – $340; a pair is about $360 – $680. Call (877) 492-1990 for a free estimate based on your door.
Pricing reflects the Old Northeast market as of 2026. Garage Door Repair Old Northeast offers free estimates – call (877) 492-1990.
What Our Customers Say
"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
- Danielle Meyer"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Michelle Wong"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Marisol Ramirez